• Remove plastic cap from the bottom of the cane and discard.


  • Caution: Bottom of cane is sharp.


  • Remove screw and washers from inside the bottom of the cane.


  • Insert the cane into the hole on top of the EZ-Step base.


  • Rotate cane until the notch in the cane locks in place with the EZ-Step base.


  • Replace screw and washers into the hole in the bottom of the EZ-Step base.


  • Be sure the flat washer is nearest the EZ-Step base while the tooth washer is nearest the top of screw.


  • Tighten  base screw securely.


  • Tighten and secure locking ring around the cane as tight as possible.